Assembly


About the Assembly category (1)
Assembly Q's (heatbed and servo) (3)
MKS Gen 1.4 ok to use? (1)
PICA Arduino Due compatibility (1)
Pica Rev E wiring SSR (4)
Questions on A Mostly Wilson TS to Wilson 2 with the kit (3)
Pica PS_ON pins? (4)
400mm cubed print area Wilson 2 ( 2 ) (26)
3 wire endstops on PICA (4)
Missing Parts ... maybe? (2)
Is Y endstop min or max? (3)
It's Alive! It's Alllliiivvee! (2)
Test fitting my Wilson 2 frame (3)
Confusion over extruder fans (3)
Z and X Rods conversion (4)
What's the difference Z-Lower-Brace and power supply (3)
Need help completing the build - 4 issues (5)
Printing Wilson II parts Questions (7)
Calibration process (7)
BoM Bearing, Nuts and Bolts, using different length and removing some of it? (4)
Heated Bed - Which side up? (6)
PICA rev c Wiring questions (5)
Cable Chain (drag chain) (14)
Loose smooth rods in the z-axis part of the design? (3)
2 little problems :) (9)
12V heatbed not heating up after assembly (1)
RAMPS jumper settings (5)
Excact dimensions of the wilson bed 20*30 (2)
Wiring the Wilson2 Heat Bed (2)
24v version PICA Control Boards (1)