New owner from Ohio


#1

Hello! Just got my new Wilson II yesterday. First reprap and 3d printer. I’ve been trying to read all I can through various places from firmware to slicers.

I’ve looked through the box and looking forward to building later on this weekend. Hope to have a good first test print.


#2

Good luck dude i just finished mine and am well chuffed


#3

First print was pretty ok. Test print on SD card the bottom layers didn’t bind or fill well enough. My guess hotend wasn’t fully primed yet. Corners aren’t bad but over-extrusion exiting the curved part. Octoprint on raspberry pi works pretty neat too. Steppers weren’t all wired the same direction. I blame the factory lol