X - Axis going too far and print fail at X > ~150mm


#1

Hi,

When my X axis goes all the way to the right during bed leveling, it slams into the right side for about 2 seconds grinding the belt. Then when I print, my print is cut off at just over X > ~150. The print head will not go past about 150 while printing.

I feel like the X end stop is not working, or I need to calibrate something, so the print head will go further right when printing.

I’ll upload a picture later …

Thanks


#2

I have similar problems and have just lived with it by not printing items as
large as I “Should” be able to. I will be interested in how your question gets answered.
Best Regards
Shawn


#3

what version of marlin are you running?